Ministries of the Republic of TatarstanMinistry of Digitalization of Public Administration, Information Technologies and Communications of the Republic of Tatarstan
Three technoparks fully staffed with residents
1 April 2015, Wednesday
Nikolay Nikiforov informed that by results of the programme 12 technoparks have opened, 10 of them are already working, and the other two in Moscow and Sverdlovsk region are about to open. The total area of premises makes 411 thousand square metres.
According to the minister, the earning of residents reached 40.5 billion roubles, whereas the contribution from the federal budget – 13.4 billion roubles.
Using materials of Russian Ministry of Communications and Mass Media
The International Competence Centre – the Kazan Technical College of Information Technologies and Communications invites graduates, their parents and all interested individuals to the Open Day event.
The event will take place on: April, 18 at 2:00 p.m.
Address: Kazan, Bar Galiyeva Street, building 3a (Sovetskaya Square bus stop).
The Rais (Head) of Tatarstan Rustam Minnikhanov approved the decision of Tatarstan government to allocate 55.3 million roubles from the regional budget to support 2,300 employees of rural postal offices in 2026.
A new practice tool for preparing for the USE has been launched on the State Services Portal (Gosuslugi)l. It allows students to reinforce their knowledge and practice solving typical exam tasks.
Since September 2024, Tatarstan residents could receive rewards through the "People’s Inspector" app for reporting traffic violations. During this period, over 12,000 reports were submitted across seven paid categories, earning citizens a total of 5.6 million roubles. The top earner was a resident of the republic who submitted 226 reports and received 275,000 roubles. The second-highest earner earned 260,800 roubles for 209 reports.
SUBSCRIBE FOR NEWS
All content on this site is licensed under
Creative Commons Attribution 4.0 International
If you see a mistake,
please select the word or sentence and press CTRL+ENTER